I/O Modules

Card Readers using Wiegand® or RS485 protocol can be connected to Door Controllers via XMP-RIM module.

The XMP-RIM module detects different protocol types automatically without particular configuration. The module provides access control via supervised inputs and relay outputs by sending the access card data to a door controller. The controller checks the validity of the access card. If the appropriate permissions have been assigned, the controller sends a message back to the XMP-RIM module allowing to unlock the door and provide access.

The following variants are available:

• XMP-RIM-001 single reader board
• XMP-RIM-002 double reader board
• XMP-RIM-003 single reader board Wiegand®
• XMP-RIM-004 double reader board Wiegand®
• XMP-RIM-005 double reader board Wiegand® without in- and outputs

Technical details:

• Power supply 12/24V DC
• Current consumption max. 3VA without peripheral devices
• Firmware update via software upload
• Max. 4 supervised inputs, 2 relay outputs
• Dimensions:
  XMP-RIM-00x: 97 x 97 x 25mm
  XMP-RIM-0x0: 125 x 125 x 30mm
  XMP-RIM-0x1: 140 x 140 x 75mm
  XMP-RIM-0x2: 235 x 345 x 125mm
• Supported Wiegand® formats:
  8 Bit transmission of numeric keypad information
  24 Bit transmission of 6 half-bytes (without parity check)
  26 Bit standard HID format
  32 Bit 4 bytes decimal (without parity check)
  34 Bit Siedle®-Vario
  35 Bit Corporate 1000 (HID)
  36 Bit Deister® MIFARE® Classic UID
  37 Bit HID-Controlled format
  40 Bit 5 bytes decimal (without parity check)
  44 Bit Deister® format TPD112

• 16 supervised inputs with 4 states (interruption, alarm, normal state, short circuit)
• Connection to the Door Control Unit XMP-K32 / XMP-K32sx (via RS485 interface) or additional to the local control module XMP-96 (via VCOM card)
• Up to 16 connectable XMP-KDM-016 modules per XMP-K32
• Supply voltage 12-24 V AC/DC via door control units

• 8-channel relay extension board for the direct switching of loads for electric door openers, optical signal devices or acoustic signal devices like horns, lamps via XMP-KDA-024 switching module
• The 24 switch commands of XMP-KDA-024 module can be extended by connection of 3 XMP-KDR-008 with 8 relays each.
• The address settings of the relay board are configured by jumpers (KDR0 to KDR2).
• The relay outputs can be set by jumpers either as control voltage applied or as dry contact.

• XMP-KDA-024 extends XMP Door Controllers with additional 24 binary outputs
• Insert to activate presence indicator boards
• Connection to XMP-K32 / XMP-K32sx via integrated RS485 interface